MATERIAL SAFETY DATA SHEETS
Glow in the Dark pigment powder
The information contained herein is based on data available at the time of preparation of this data sheet which EHCLLC believes to be reliable. However, no warranty is expresses or implied regarding the accuracy of this data. EHCLLC shall not be responsible for the use of this information, or of any product, method or apparatus mentioned and you must make your own determination of its suitability and completeness for your own use, for the protection of the environment, and the health and safety of your employees and the users of this material. Complies with OSHA hazard communication standard 29CFR1910.1200
1. PRODUCT IDENTIFICATION
Product Name:EHCGLOW Glow in the Dark acrylic paint
2. COMPOSITION / INFORMATION ON INGREDIENTS
Common name:Titanium dioxide Chemical name:Titanium dioxide Cas Number:13463-67-7 % by Weight:5-20
Common name:Texanol Chemical name: ropanic acid,2-methyl, monoester with 2,2,4-trimethyl-1,3-pentanediol Cas Number:25265-77-4 % by Weight:2-6
Common name:Water Chemical name:Water Cas Number:7732-18-5 % by Weight:20-50
Common name:Acrylic resin Chemical name:Acrylic resin Cas Number:Sup.conf % by Weight:15-45
Common name:Sodium salt of maleic acid Chemical name:Dispersion solution Cas Number:Sup.conf % by Weight:0.3-1.5
3. HAZARDS IDENTIFICATION
Exposure Limit: ACGIH-TLV 2mg/ m3
OSHA-PEL 3mg/ m3
Routes of exposure: Inhalation of vapor or spray mist, skin contact, eye contact, ingestion.
Effect of overexposure:
Eye contact: May cause irritation.
Skin contact: May cause irritation.
Ingestion: May cause irritation.
Inhalation: Irritation of the upper respiratory tract. Prolonged inhalation may lead to headache, nausea, coughing.
Listed Carcinogen: None.
4. FIRST-AID MEASURES
Eyes contact: Rinse eyes immediately with large amounts of water for at least 15 minutes. If irritation or other effect persist get medical attention.
Skin contact: Rinse affected area thoroughly with soap and water. If irritation persists, seek medical attention. Remove contaminated clothing and wash it before use.
Ingestion: Get medical attention and treatment immediately.
Inhalation: Remove to exposure or in the fresh air, Restore and support breathing. Get medical help any breathing difficulty. Seek medical attention if symptoms persist.
5. FIRE-FIGHTING MEASURES
Fire extinguishing media: Dry chemical. Carbon dioxide. Foam.
Unusual fire and explosion hazards. Closed containers may explode or burst when exposed to extreme heat.
Fire fighting procedures: Water may be used to cool and protect exposed containers. Firefighters should use full protective clothing, eye protection, and self-contained breathing apparatus. Full protective equipment including self-contained breathing apparatus should be used.
Hazardous decomposition or combustion products: Carbon monoxide, carbon dioxide, monomer vapors, acrylic monomers.
FLASH POINT Not Applicable
Carbon Dioxide, Dry Chemical, Alcohol Foam
6. ACCIDENTAL RELEASE MEASURES
Steps to be taken in case material is released or spilled: Comply with all applicable health and environmental regulations. Ventilate the area. Use personal protective equipment & respiratory protection during cleanup. Eliminate all sources of ignition. Ventilate area. Spills may be collected with absorbent materials. Evacuate all unnecessary personnel. Place collected material in proper container. Spilled material is extremely slippery. Complete personal protective equipment must be used during cleanup. Large spills – shut off leak if safe to do so. Dike and contain spill. Pump to storage or salvage vessels. Use absorbent to pick up excess residue. Keep salvageable material and rinse water out of sewers and water courses. Small spills – use absorbent to pick up residue and dispose of properly.
7. HANDLING AND STORAGE PRECAUTIONS
Handling: Store below 100f (38c). Keep from freezing.
Other Precautions: Use only with adequate ventilation. Do not take internally. Keep out of reach of children. Avoid contact with skin and eyes, and breathing of vapors. Wash hands thoroughly after handling, especially before eating or smoking. Keep containers tightly closed and upright when not in use.
8. EXPOSURE CONTROL AND PERSONAL PROTECTION
Respiratory protection : Where respiratory protection is required, use only NIOSH/ MSHA approved respirators in accordance with OSHA standard 29 CFR 1910.134.
Ventilation : Provide dilution ventilation or local exhaust to prevent build-up of vapors.
Personal protective equipment : Eye wash, safety shower, safety glasses or goggles. Impervious gloves, impervious clothing. Replace elastomeric protective equipment whenever it becomes swollen, gummy, torn, or shows evidence of barrier loss. Apply a solvent-resistant skin barrier cream to areas of skin that may come into contact with material. If working out-of-doors, apply sunscreen lotion with a high sun block protection factor to skin exposed to sunlight after applying barrier cream.
9. STABILITY AND REACTIVITY
Under normal conditions : Stable see section 5 fire fighting measures
Materials to avoid : Oxidizers, acids.
Conditions to avoid : Elevated temperatures, contact with oxidizing agent, freezing, sparks, open flame, extremes in temperature.
Hazardous polymerization : Will not occur
10. TOXICOLOGICAL INFORMATION
Supplemental health information : No additional effects are anticipated
Carcinogenicity : In a lifetime inhalation study, exposure to 250 mg/m3 titanium dioxide resulted in the development of lung tumors in rats. These tumors occurred only at dust levels that
overwhelmed the animals’ lung clearance mechanisms and were different from common human
lung tumors in both type and location. The relevance of these findings to humans is unknown
but questionable. The international agency for research on cancer (IARC) has classified
titanium dioxide as possibly carcinogenic to humans (group 2b) based on inadequate evidence
of carcinogenicity in humans and sufficient evidence of carcinogenicity in experimental animals.
Reproductive effects : No reproductive effects are anticipated
Mutagenicity : No mutagenic effects are anticipated
Teratogenicity : No teratogenic effects are anticipated
11. ECOLOGICAL INFORMATION
Ecological toxic effects: Quantitative data on the ecological effect of this product is not available.
12. DISPOSAL CONSIDERATION
Dispose of in accordance with all applicable local, state, federal, and environmental regulations.
13. TRANSPORT INFORMATION
Not subject to transport regulations.
14. REGULATORY INFORMATION
As of the date of this MSDS, all of the components in this product are listed (or are otherwise exempt from listing) on the TSCA inventory. This product has been classified in accordance with the hazard criteria of the CPR (controlled products regulations) and the MSDS contains all the information required by the CPR.
Physical Data (ANSI Sections 1, 9, and 14)
Description Wt. / Gal.
gr. / ltr.
HMIS DOT, proper shipping name
GL 7111 glidden interior/exterior latex gloss paint base 1 10.04 2.00 64.40 none 212-212 110 paint ** protect from freezing **
GL 7112 glidden interior/exterior latex gloss paint base 2 8.79 47.70 67.99 none 212-501 110 paint ** protect from freezing **
GL 7113 glidden interior/exterior latex gloss paint base 3 8.65 47.81 68.51 none 212-501 110 paint ** protect from freezing **
Ingredients Product Codes with % by Weight (ANSI Section 2)
Chemical Name Common Name CAS. No. GL 7111 GL 7112 GL 7113
titanium oxide titanium dioxide 13463-67-7 10-20 1-5
propanoic acid, 2-methyl-, monoester with 2,2,4-trimethyl-1,3-pentanediol texanol 25265-77-4 1-5 1-5
water water 7732-18-5 50-60 60-70 60-70
ammonium salt of polycarboxylic acid polymeric dispersant solution Sup. Conf. 1-5 1-5
acrylic resin acrylic resin Sup. Conf. 20-30 20-30 30-40
Chemical Hazard Data (ANSI Sections 2, 8, 11, and 15)
ACGIH-TLV OSHA-PEL S.R.
S2 S3 CC
Common Name CAS. No. 8-Hour TWA STEL C S 8-Hour TWA STEL C S H M N I O
titanium dioxide 13463-67-7 10 mg/m3 not est. not est. not est. 10 mg/m3 not est. not est. not est. not est. n n n n n y y n
texanol 25265-77-4 not est. not est. not est. not est. not est. not est. not est. not est. not est. n n n n n n n n
polymeric dispersant solution Sup. Conf. not est. not est. not est. not est. not est. not est. not est. not est. not est. n n n n n n n n
Footnotes: H=Hazardous Air Pollutant, M=Marine Pollutant
C=Ceiling – Concentration that S=Skin – Additional exposure, n/a=not applicable ppm=parts per million S2=Sara Section 302 EHS P=Pollutant, S=Severe Pollutant
should not be exceeded, over and above airborn exposure, not est=not established mg/m3=milligrams per cubic meter S3=Sara Section 313 Chemical Carcinogenicity Listed By:
even instantaneously. may result from skin absorption. CC=CERCLA Chemical Sup Conf=Supplier Confidential S.R.Std.=Supplier Recommended Standard N=NTP, I=IARC, O=OSHA, y=yes, n=no
13. DEFINITIONS AND ABBREVIATIONS
ACGIH = American Conference of Governmental Industrial Hygienists
CAS = Chemical Abstracts Service Registry Number
EPA = Environmental Protection Agency
NOISH = National Institute for Occupational Safety and Health
OSHA = Occupational Safety and Health Administration
PEL = Permissible Exposure Limits
SARA = Superfund Amendments and Reauthorization Act
Notice to Reader
To the best of our knowledge, the information mentioned above is accurate. We have reviewed any information contained in this data sheet which we received from source outside our company. We believe that information to be correct but cannot guarantee its accuracy or completeness. However, the final determination of the suitability of any material is the sole responsibility of the user. Health and safety precautions in this data sheet may not be adequate for all individuals and/or situations. All materials may present unknown hazards and should be used with caution. Although certain hazards are described herein, we cannot guarantee these are the only hazards existing. It is the user’s obligation to evaluate and use this product safety and to comply with all applicable laws and regulations. No statement made in this data sheet shall be construed as a permission or recommendation for the use of any product in a manner that might infringe existing patents. No warranty is made, either expresses or implied.